		Search-engine friendly clone of the ACL2 documentation.

Ccl-installation

Ccl-installation-linux-elaborate

Installing Clozure Common Lisp (CCL) on Linux (elaborate version)

NOTE: See the Clozure CL releases page for the latest information, which may supersede some of what is included below.

See ccl-installation for introductory remarks. The ``cookbook'' instructions below give you one way to install CCL on Linux without any knowledge of git or CCL. For more streamlined instructions see ccl-installation-linux-brief.

Note: Linux users may need to install m4.

First fetch CCL from GitHub as follows. (You may prefer to use ``git pull'' if you previously did this step. In that case you probably won't want to do the optional renaming of the directory, mentioned below.)

# Obtain a ccl distribution in a fresh directory:
mkdir temp
cd temp
git clone https://github.com/Clozure/ccl
# Optionally rename that directory as suggested below, after
# executing the following three commands.
cd ccl
git rev-parse HEAD
cd ../../
# Optionally change directory name, and then go back to ccl directory:
# You'll want the last 10 hex digits to match those of the
# output from the ``git rev-parse HEAD'' command above: do
# that twice here and once further below.
mv temp 2017-12-07-6be8298fe5
cd 2017-12-07-6be8298fe5/ccl

Next fetch and extract a development snapshot. The version below is current as of this writing (December, 2021), but see https://github.com/Clozure/ccl/releases/ for the latest snapshots.

wget https://github.com/Clozure/ccl/releases/download/v1.12.1/linuxx86.tar.gz
tar xfz linuxx86.tar.gz

Rebuild and quit, twice.

echo '(rebuild-ccl :full t)' | ./lx86cl64
echo '(rebuild-ccl :full t)' | ./lx86cl64

Create an executable script like the following. You might want to call it ``ccl'' and put it into a directory on your path. Be sure to change the name (shown as ``2017-12-07-6be8298fe5'' above) to match the name change already made above.

#!/bin/sh

export CCL_DEFAULT_DIRECTORY=/projects/acl2/lisps/ccl/2017-12-07-6be8298fe5/ccl
${CCL_DEFAULT_DIRECTORY}/scripts/ccl64 "$@"

Now ensure that your script is executable, e.g.:

chmod +x my-script

You're done! (Note however that certification of books that use Quicklisp may require openssl to be installed if it is not already on your system.)